The mechanism of capillaries hydraulic conductivity evolution under confining pressure: Experimental modelling using 3D-printing approach
Abstract view|9|times PDF download|5|times
Abstract
The effect of confining pressure on the hydraulic conductivity of capillaries in cylindrical samples is examined. The three-dimensional-printed samples were made from photopoly-mer resin. Capillaries in the samples were modeled by grooves of various geometric shapes. The mechanism of capillary deformation in the samples under increasing confining pressure has been identified. The change in capillary conductivity depending on their location (central and lateral) and configuration (sinuous) has been revealed. Based on correction functions for the geometric dimensions of the capillaries, it has been mathematically confirmed that under confining pressure, a capillary deforms primarily along the contact plane due to the sliding of the sample’s halves against each other. The width of a capillary is more sensitive to confining pressure than its depth. It has been established that the exponent in the conductivity (permeability) equation of the samples under cyclic loading is determined by the hydraulic area of the capillary. The obtained values of the width and depth correction factors allow for predicting changes in the filtration resistances of capillaries in various materials. Capillary deformation manifests as a change in its geometric dimensions (height and width), i.e., the crushing of the capillary banks is observed, leading to a reduction in the capillary’s hydraulic area, which causes a decrease in sample conductivity with an incomplete hysteresis.
Document Type: Original article
Cited as: Riabokon, E., Turbakov, M., Kozhevnikov, E., Kobiakov, D., Ivanov, Z., Guzev, M., Yu, L. The mechanism of capillaries hydraulic conductivity evolution under confining pressure: Experimental modelling using 3D-printing approach. Capillarity, 2025, 17(3): 97-108. https://doi.org/10.46690/capi.2025.12.03
Keywords
Full Text:
PDFReferences
Aghajani, M., Maruf, S. H., Wang, M., et al. Relationship between permeation and deformation for porous membranes. Journal of Membrane Science, 2017, 526: 293-300.
Al Mteiri, S., Suboyin, A., Rahman, M. M., et al. Hydraulic fracture propagation and analysis in heterogeneous middle eastern tight gas reservoirs: Influence of natural fractures and well placement. ACS Omega, 2020, 6(1): 799-815.
Almubarak, M., Germaine, J. T., Einstein, H. H. Fracturing processes in specimens with internal vs. throughgoing f laws: An experimental study using 3D printed materials. Rock Mechanics and Rock Engineering, 2024.
Yang, L., Wang, S., Cai, J., et al. Main controlling factors of fracturing fluid imbibition in shale fracture network. Capillarity, 2018, 1(1): 1-10.
Azin, R., Kazemi, F., Hosseini, S. T., et al. 3D-printed synthetic core plugs: Advancing laboratory simulations for enhanced oil recovery. Results in Engineering, 2025, 26: 105077.
Bandis, S. C., Lumsden, A. C., Barton, N. R. Fundamentals of rock joint deformation. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 1983, 20(6): 249-268.
Bo, M. W., Arulrajah, A., Horpibulsuk, S., et al. Laboratory measurements of factors affecting discharge capacity of prefabricated vertical drain materials. Soils and Foundations, 2016, 56(1): 129-137.
Boro, H., Rosero, E., Bertotti, G. Fracture-network analysis of the Latemar Platform (northern Italy): Integrating outcrop studies to constrain the hydraulic properties of fractures in reservoir models. Petroleum Geoscience, 2014, 20(1): 79-92.
Chen, S., Zhang, J., Yin, D., et al. Visualizing experimental investigation on gas-liquid replacements in a microcleat model using the reconstruction method. Deep Underground Science and Engineering, 2023, 2(3): 295-303.
Dawson, M. A., Germaine, J. T., Gibson, L. J. Permeability of open-cell foams under compressive strain. International Journal of Solids and Structures, 2007, 44(16): 5133-5145.
Eschweiler, J., Horn, N., Rath, B., et al. The biomechanics of cartilage-an overview. Life, 2021, 11(4): 302.
Fan, T., Song, X., Wu, S., et al. A mathematical model and numerical simulation of waterflood induced dynamic fractures of low permeability reservoirs. Petroleum Exploration and Development, 2015, 42(4): 541-547.
Feng, P., Ma, H., Wang, J., et al. Influence mechanism of confining pressure on the hydraulic aperture based on the fracture deformation constitutive law. Frontiers in Earth Science, 2023, 10: 968696.
Gehne, S., Benson, P. M. Permeability enhancement through hydraulic fracturing: laboratory measurements combining a 3D printed jacket and pore fluid over-pressure. Scientific Reports, 2019, 9(1): 12573.
Goodman, R. E. Introduction to Rock Mechanics. New York, USA, 1989.
Goodman, R. The mechanical properties of joints. Paper Presented at the Third International Congress International Society for Rock Mechanics, Denver, Colorado, 1-7 September, 1974.
Hofmann, H., Blöcher, G., Milsch, H., et al. Transmissivity of aligned and displaced tensile fractures in granitic rocks during cyclic loading. International Journal of Rock Mechanics and Mining Sciences, 2016, 87: 69-84.
Ibrahim, E. R., Jouini, M. S., Bouchaala, F., et al. Simulation and validation of porosity and permeability of synthetic and real rock models using three-dimensional printing and digital rock physics. ACS Omega, 2021, 6(47): 31775-31781.
Kamal, M. A., Rabie, M. H., Hussein, H. M., et al. Numerical and field study of wick drains performance in soft clay. Innovative Infrastructure Solutions, 2025, 10(5): 193.
Ketova, Yu.A. Relevant directions in development of polymer compositions for conditions of operated in Perm region reservoirs. Perm Journal of Petroleum and Mining Engineering, 2017, 16(4): 342-349.
Khetabi, E. M., Bouziane, K., Zamel, N., et al. Effects of mechanical compression on the performance of polymer electrolyte fuel cells and analysis through in-situ characterisation techniques-A review. Journal of Power Sources, 2019, 424: 8-26.
Kim, H. M., Inoue, J. Analytical approach for anisotropic permeability through a single rough rock joint under shear deformation. Journal of Geophysical Research, 2003, 108(B8): 2366.
Kluge, C., Blöcher, G., Hofmann, H., et al. The stressmemory effect of fracture stiffness during cyclic loading in low-permeability sandstone. Journal of Geophysical Research: Solid Earth, 2021, 126(10): e2020JB021469.
Kozhevnikov, E. V., Turbakov, M. S., Riabokon, E. P., et al. Cyclic confining pressure and rock permeability: Mechanical compaction or fines migration. Heliyon, 2023, 9(11): e21600.
Kozhevnikov, E., Turbakov, M., Riabokon, E., et al. Rock permeability evolution during cyclic loading and colloid migration after saturation and drying. Advances in Geo-Energy Research, 2024, 11(3): 208-219.
Kozhevnikov, E., Turbakov, M., Riabokon, E., et al. Effect of load vector orientation on uniaxial compressive strength of 3D photoresin. Journal of Manufacturing and Materials Processing, 2025, 9(1): 23.
Kuganeswaran, N., Rahim, A., Ali, N. Consolidation in soft soil-case study on prefabricated vertical drains (PVDs). The Open Civil Engineering Journal, 2021, 15(1): 310-319.
Ma, K., Wang, S., Zhang, L., et al. A microfluidic study on the influence of naturally fractured porous media on the phase behavior of condensate gas depletion. Natural Gas Industry B, 2025, 12(4): 432-446.
Ouf, M., Jørgensen, P. R., Mosthaf, K., et al. Estimation of effective fracture aperture in glacial tills by analysis of dye tracer penetration. Groundwater, 2024, 63(1): 25-40.
Paluszny, A., Matthai, S. K. Impact of fracture development on the effective permeability of porous rocks as determined by 2-D discrete fracture growth modeling. Journal of Geophysical Research: Solid Earth, 2010, 115(B2): B02203.
Persson, K. M., Gekas, V., Trägårdh, G. Study of membrane compaction and its influence on ultrafiltration water permeability. Journal of Membrane Science, 1995, 100(2): 155-162.
Petitjean, N., Canadas, P., Royer, P., et al. Cartilage biomechanics: From the basic facts to the challenges of tissue engineering. Journal of Biomedical Materials Research Part A, 2022, 111(7): 1067-1089.
Planas-Paz, L., Lammert, E. Mechanical forces in lymphatic vascular development and disease. Cellular and Molecular Life Sciences, 2013, 70(22): 4341-4354.
Poplygin, V., Dieng, A., Shi, X. Forecasting hydraulic fracturing results using information amount theory. Perm Journal of Petroleum and Mining Engineering, 2024, 24(2): 93-100.
Rong, G., Huang, K., Zhou, C. A new constitutive law for the nonlinear normal deformation of rock joints under normal load. Science China Technological Sciences, 2011, 55(2): 555-567.
Sun, G. Z., Lin, W. Z. The compressional deformation law of rock mass structure surface and a constitutive equation of rock mass elastic deformation. Chinese Journal of Geology, 1983, 18(2): 177-180.
Tran-Nguyen, H. H., Edil, T. B., Schneider, J. A. Effect of deformation of prefabricated vertical drains on discharge capacity. Geosynthetics International, 2010, 17(6): 431-442.
Vogler, D., Amann, F., Bayer, P., et al. Permeability evolution in natural fractures subject to cyclic loading and Gouge formation. Rock Mechanics and Rock Engineering, 2016, 49(9): 3463-3479.
Wang, G., Liu, Y., Huang, Q., et al. Experimental study on the influence of coal fracture surface roughness on water injection seepage. ACS Omega, 2022, 7(36): 32679-32689.
Wei, J., Shang, D., Zhao, X., et al. Experimental study on production characteristics and enhanced oil recovery during imbibition and huff-n-puff injection in shale reservoir. Capillarity, 2024, 12(2): 41-56.
Witherspoon, P. A., Wang, J. S. Y., Iwai, K., et al. Validity of cubic law for fluid flow in a deformable rock fracture. Water Resources Research, 1980, 16(6): 1016-1024.
Xue, R., Chang, Y., Wang, S., et al. Pore-scale microfluidic investigation of unsaturated CO2 bubble morphology and interface evolution during drainage-imbibition cycles. Capillarity, 2025, 15(3): 74-86.
Xue, R., Chang, Y., Wang, S., et al. A new fracture permeability model: Influence of surrounding rocks and matrix pressure. Journal of Petroleum Science and Engineering, 2020, 193: 107320.
Zhou, J., Luo, L., Yu, L., et al. Experimental study about the influence of cyclic load on the hydraulic conductivity of clay. Acta Geotechnica, 2020, 15(12): 3357-3370.
Zuo, J., Chen, Y., Liu, X. Crack evolution behavior of rocks under confining pressures and its propagation model before peak stress. Journal of Central South University, 2019, 26(11): 3045-3056.
Refbacks
- There are currently no refbacks.
Copyright (c) 2025 The Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.