Injection parameters optimization of crosslinked polymer flooding by genetic algorithm
Abstract view|345|times PDF download|188|times
Abstract
The crosslinked polymer flooding, which is developed on the basis of polymer flooding, is a new type of flooding technology. As an EOR method, cross-linked polymer flooding has become a research hotspot. In the process of cross-linked polymer flooding, if the concentrations of the polymer and the crosslinking agent are small, the viscosity of the solution is low, and it will not achieve the oil displacement effect. Meanwhile, if the concentrations of the polymer and crosslinking agent are large, the viscosity of the solution is high, it needs high pressure to drive it flowing in the formation. Further, with the increasing injection of chemical agents, the contradiction between reduced production and increased cost has presented. The performance of crosslinked polymer flooding depends on the interaction of these two factors. Therefore, the concentrations of polymer and crosslinking agent should be optimized. In this paper, an optimal design method is proposed by using genetic algorithm with global optimization characteristics algorithm, combining with the chemical flooding numerical simulation software UTCHEM, the concentrations of the chemical agents are optimized. Firstly, the cumulative oil production is calculated by numerical simulation software UTCHEM, then the concentrations of the chemical agents are randomly generated by the genetic algorithm in the encoding process, and the fitness function takes the profit of cross-linked polymer flooding. Given a set of initial values, through crossover and mutation of population, optimized injection concentrations of the polymer and cross-linking agent are obtained by the multi-generational calculation.
Cited as: Lian, P., Li, L., Duan, T. Injection parameters optimization of crosslinked polymer flooding by genetic algorithm. Advances in Geo-Energy Research, 2018, 2(4): 441-449, doi: 10.26804/ager.2018.04.08
Keywords
Full Text:
PDFReferences
Albonico, P., Bartosek, M., Malandrino, A., et al. Studies on phenol-formaldehyde crosslinked polymer gels in bulk and in porous media. Paper SPE 28983 Presented at the SPE International Symposium on Oilfield Chemistry, San Antonio, Texas, 14-17 February, 1995.
Brattek ˚as, B., Graue, A., Seright, R.S. Low salinity chase waterfloods improve performance of Cr(III)-acetate HPAM gel in fractured cores. Paper SPE 173749 Presented at the SPE International Symposium on Oilfield Chemistry, The Woodlands, Texas, USA, 13-15 April, 2015.
Cao, R., Cheng, L., Lian, P. Flow behavior of viscoelastic polymer solution in porous media. J. Disper. Sci. Technol. 2015, 36(1): 41-50.
Carpenter, C. Production-optimization strategy using a hybrid genetic algorithm. J. Pet. Technol. 2016, 68(12): 54-55.
Ebaga-Ololo, J., Chon, B.H. Prediction of polymer flooding performance with an artificial neural network: A two-polymer-slug case. Energies 2017, 10(7): 844.
El-Karsani, K.S.M., Al-Muntasheri, G.A., Hussein, I.A. Poly-mer systems for water shutoff and profile modification: A review over the last decade. SPE J. 2014, 19(1): 135-149.
Fakher, S., Bai, B. A newly developed mathematical model to predict hydrolyzed polyacrylamide crosslinked polymer gel plugging efficiency in fractures and high permeability features. Paper SPE 191180 Presented at the SPE Trinidad and Tobago Section Energy Resources Conference, Port of Spain, Trinidad and Tobago, 25-26 June, 2018.
Flory, P.J. Thermodynamics of high polymer solutions. J. Chem. Phys. 1942, 10(1): 51-61.
He, H., Wang, Y., Zhang, J., et al. Comparison of gelation behavior and morphology of resorcinol-hexamethylenetetramine-HPAM gel in bulk and porous media. Transp. Porous Media 2015, 109(2): 377-392.
Himes, R.E., Ali, S.A., Hardy, M.A., et al. Reversible, crosslinkable polymer for fluid-loss control. Paper SPE 27373 Presented at the SPE Formation Damage Control Symposium, Lafayette, Louisiana, 7-10 February, 1994.
Huang, B., Zhang, W., Xu, R., et al. A Study on the matching relationship of polymer molecular weight and reservoir permeability in ASP flooding for Duanxi reservoirs in Daqing oil field. Energies 2017, 10(7): 951.
Huggins, M.L. Solutions of long chain compounds. J. Chem. Phys. 1941, 9(5): 440-440.
Jayakumar, S., Lane, R.H. Delayed crosslink polymer flowing gel system for water shutoff in conventional and unconventional oil and gas reservoirs. Paper SPE 151699 Presented at the SPE International Symposium and Exhibition on Formation Damage Control, Lafayette, Louisiana, USA, 15-17 February, 2012.
Jiang, W., Lu, X., Liu, Y., et al. An experimental study on flooding effects of chromium-organic cross-linked polymer in heavy oilfields. China Offshore Oil and Gas 2008, 20(2): 103-110. (in Chinese)
Lenchenkov, N., Glasbergen, G., Kruijsdijk, C. Flow of a cross-linking polymer in porous media. Transp. Porous Media 2018, 2018: 1-21.
Li, J., Ma, J., Liu, Y., et al. Optimizing injection parameters of polymer flooding in offshore oilfields by combining surrogate model and genetic algorithm. China Offshore Oil and Gas 2012, 24(4): 41-44. (in Chinese)
Li, X., Zhang, L., Zhang, J. Application of improved genetic algorithm to oilfield well array optimization. Petroleum Geology and Recovery Efficiency 2006, 13(2): 68-71. (in Chinese)
Li, Y., Kong, B., Li, C. Dynamic characteristics of synergistic effect between profile technology throughout flooding and ASP flooding. Acta Petrolei Sinica 2018, 39(6): 698-702. (in Chinese)
Lian, P., Tong, D., Li, L. Development of crosslinked polymer flooding in high temperature and high salt reservoirs. Advances in Fine Petrochemicals 2010, 11(7): 4-7. (in Chinese)
Liu, H., Wang, Y., Li, G., et al. An enhanced oil recovery technology continually after polymer-flooding. Paper SPE 144250 Presented at the SPE Enhanced Oil Recovery Conference, Kuala Lumpur, Malaysia, 19-21 July, 2011.
Liu, Y., Dai, C., Wang, K., et al. New insights into the hy-droquinone (HQ)-hexamethylenetetramine (HMTA) gel system for water shut-off treatment in high temperature reservoirs. J. Ind. Eng. Chem. 2016, 35: 20-28.
Liu, Y., Lian, P., Tong, D., et al. Optimum design of the horizontal section length in a horizontal well using genetic algorithm. Acta Petrolei Sinica 2008, 29(2): 296-299. (in Chinese)
Lu, X., Xie, K., Cao, B., et al. Study on gelling effect of Cr(III) polymer gel and its influence factors. Journal of China University of Petroleum 2015, 39(3): 170-176. (in Chinese)
Luo, Y., Zhang, Y., Dang, J. Laboratory study of HPAM/Cr(III) weak gel and profile control system. Journal of Yangtze UNiversity (Nat Sci Edit) 2005, 2(4): 311-313.
(in Chinese) Melanie, M. An Introduction to Genetic Algorithms. Cam-bridge, England, The MIT Press, 1998.
Mody, B.G., McKitrick, R.S., Shahsavari, D. Proper applica-tion of crosslinked polymer decreases operating costs. Paper SPE 17288 Presented at the Permian Basin Oil and Gas Recovery Conference, Midland, Texas, 10-11 March, 1988.
Montes, G., Bartolome, P., Udias, A.L. The use of genetic algorithms in well placement optimization. Paper SPE 69439 Presented at the SPE Latin American and Caribbean Petroleum Engineering Conference, Buenos Aires, Argentina, 25-28 March, 2001.
Nguyen, T.Q., Green, D.W., Willhite, G.P., et al. Effect of com-position of a polyacrylamide-chromium(III) acetate gel on the magnitude of gel dehydration and disproportionate permeability reduction. Paper SPE 89404 Presented at the SPE/DOE Symposium on Improved Oil Recovery, Tulsa, Oklahoma, 17-21 April, 2004.
Pope, G.A., Nelson, R.C. A chemical flooding compositional simulator. Soc. Pet. Eng. J. 1978, 18(5): 339-354.
Pope, G.A., Sepehrnoori, K., Sharma, M.M., et al. Three-dimensional NAPL fate and transport model. 1999.
Shen, D., Li, W., Jin, D., et al. Shuanghe Oilfield VII upper test displacement effect of temperature and salt resisting crosslinked polymer and understanding. J. Oil Gas Technol. 2010, 32(5): 326-328.
Shriwal, P., Lane, R.H. Impacts of timing of crosslinker addition on water shutoff polymer gel properties. Paper SPE 153241 Presented at the SPE Improved Oil Recovery Symposium, Tulsa, Oklahoma, USA, 14-18 April, 2012.
Song, W., Zeng, X., Yao, H., et al. Application of a new crosslinked polymer displacement technology at Bo-19 Block in Gudao oilfield. Paper SPE 77797 Presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, Melbourne, Australia, 8-10 October, 2002.
Wang, J., Sheng, P., Li, Z., et al. Experimental investigation of crosslink polymer plugging in horizontal heterogeneous reservoir. Acta Petrolei Sinica 2002, 23(3): 60-64. (in Chinese)
Wang, X., Cao, L. Genetic algorithms-theory, applications and software implements. Xi’an, China, Xian Jiaotong University press, 2002. (in Chinese)
Wei, C. Organic cross-linked polymer flooding test injection in Shengtuo high temperature and high salinity reservoir. Petroleum Geology and Recovery Efficiency 2007, 14(5): 69-71. (in Chinese)
Wood, D.A. Dual objective oil and gas field development project optimization of stochastic time cost tradeoff problems. Adv. Geo-Energy Res. 2018, 2(1): 14-33.
Xie, C., Guan, Z., Blunt, M., et al. Numerical simulation of oil recovery after cross-linked polymer flooding. J. Can. Pet. Technol. 2009, 48(4): 37-41.
Yang, J., Xie, X., Zhang, J., et al. Injection parameters optimization of cross-linked polymer microspheres and polymer composite flooding system. Pet. Explor. Dev. 2014, 41(6): 794-797.
Yin, X., Wang, L., Jin, Y., et al. The parameter optimal design of whole block water-plug and profile control after polymer flooding. Sci. Technol. Eng. 2013, 13(5): 1285-1288.
Yuan, F., Mu, T., Wei, C. A fast solution to the mathematical model of cross-linked polymer flooding. Journal of Southwest Petroleum Institute 2014, 36(6): 128-134. (in Chinese)
Zhang, G., Liu, D., Liu, Z., et al. Determining injection parameters of crosslinked polymerflood slug by using optimization method. J. Oil Gas Technol. 2010, 32(1): 136-140.
Zheng, B., Hou, J., Zhang, M., et al. Research on oil displacement mechanism of crosslinked polymer using CT technique. Xinjiang Petroleum Geology 2016, 37(1): 97-101. (in Chinese)
Zhou, Y., Guo, J., Wang, T., et al. A high temperature and high salinity resistant particulated precrosslinked gel and its use for reservoir permeability adjustment. Oilfield Chem. 2007, 24(1): 75-78.
Refbacks
- There are currently no refbacks.
Copyright (c) 2018 The Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.