Impact of four different CO2 injection schemes on extent of reservoir pressure and saturation
Abstract view|650|times PDF download|257|times
Abstract
This study investigates how four different injection schemes, (i. constant rate, ii. stepwise increasing rate, iii. stepwise decreasing rate, and iv. cyclic rate), constrained by the cumulative amount of CO2 injected, affect the likely extent of pressure buildup and CO2 plume, which play a role in the appraisal of environmental risk performance at CO2 storage sites. This objective is achieved using a representative model of a realistic site consisting of multi-layer sandstone that is extremely permeable (between 1 to 2 Darcy) and separated by thin layers of shale extending laterally with sporadic discontinuities in form of perforations. Results show that cyclic injection tends to keep the pore pressure lower than the other three injection schemes, while the highest pressure increase over the entire injection period (50 years) is observed with stepwise decreasing rate. The compressibility of CO2 plays a role in attenuating the impact of fluctuating cyclic injection signals on pressure after 30 years of injection, where this time decreases by 5 years in case of heterogeneous scenario. Except for the cyclic injection scheme, all other three injection schemes lead to almost the same magnitude and areal extent of CO2 saturation, while it shows a cyclic behavior in the case of the cyclic injection. Major observations are similar in both homogeneous and heterogeneous scenarios, although layered heterogeneity in the representative site introduces small differences in results. The results imply that it would be preferable to store CO2 using a cyclic injection scheme in storage reservoirs that may be prone to high pressure buildup during injection because of their geology (e.g. fractured shale reservoirs). These results also carry important implications for enhanced oil recovery (EOR) using CO2 where the primary goal is to drive the oil out by increasing pore pressure; for EOR by CO2 , stepwise decreasing rate would be most preferable as it leads to highest increase in pore pressure.
Cited as: Singh, H. Impact of four different CO2 injection schemes on extent of reservoir pressure and saturation. Advances in Geo-Energy Research, 2018, 2(3): 305-318, doi: 10.26804/ager.2018.03.08
Keywords
Full Text:
PDFReferences
Bachu, S., Bennion, B. Effects of in-situ conditions on relative permeability characteristics of CO2 -brine systems. Environ. Geol. 2008, 54(8): 1707-1722.
Bachu, S., Celia, M.A. Assessing the potential for CO2 leakage, particularly through wells, from geological storage sites. Geophys. Monogr. Ser. 2009, 183: 203-216.
Bandilla, K.W., Kraemer, S.R., Birkholzer, J.T. Using semi-analytic solutions to approximate the area of potential impact for carbon dioxide injection. Int. J. Greenhouse Gas Control 2012, 8: 196-204.
Bateman, K., Rochelle, C., Lacinska, A., et al. CO2 -porewater-rock reactions-Large-scale column experiment (Big Rig II). Energy Procedia 2011, 4: 4937-4944.
Berg, S., Oedai, S., Ott, H. Displacement and mass transfer between saturated and unsaturated CO2 -brine systems in sandstone. Int. J. Greenhouse Gas Control 2013, 12: 478-492.
Bhowmik, S. Predicting the migration of CO2 plume in saline aquifers using probabilistic history matching approaches. Austin, University of Texas at Austin, 2012.
Birkholzer, J., Cihan, A., Bandilla, K. A tiered areaofreview framework for geologic carbon sequestration. Greenhouse Gases 2014, 4(1): 20-35.
Birkholzer, J.T., Oldenburg, C.M., Zhou, Q. CO2 migration and pressure evolution in deep saline aquifers. Int. J. Greenhouse Gas Control 2015, 40: 203-220.
Bromhal, G., ArcentalesBastidas, D., Birkholzer, J., et al. Use of science-based prediction to characterize reservoir behavior as a function of injection characteristics, geological variables, and time. NRAP-TRS-I-005-2014, Department of Energy, National Energy Technology Laboratory, USA, 2014.
Carey, J.W., Svec, R., Grigg, R., et al. Experimental investigation of wellbore integrity and CO2 -brine flow along the casing-cement microannulus. Int. J. Greenhouse Gas Control 2010, 4(2): 272-282.
Celia, M.A., Nordbotten, J.M. How simple can we make models for CO2 injection, migration, and leakage? Energy Procedia 2011, 4: 3857-3864.
Dempsey, D., Kelkar, S., Pawar, R., et al. Modeling caprock bending stresses and their potential for induced seismicity during CO2 injection. Int. J. Greenhouse Gas Control 2014, 22: 223-236.
Doughty, C. Investigation of CO2 plume behavior for a large-scale pilot test of geologic carbon storage in a saline formation. Transp. Porous Media 2010, 82(1): 49-76.
Dykstra, H., Parsons, R.L. The prediction of oil recovery by waterflood. Secondary Recovery of Oil in the United States 1950, 2: 160-174.
Ellis, B., Peters, C., Fitts, J., et al. Deterioration of a fractured carbonate caprock exposed to CO2 -acidified brine flow. Greenhouse Gases 2011, 1(3): 248-260.
Fragoso, A., Selvan, K., Aguilera, R. Breaking a paradigm: Can oil recovery from shales be larger than oil recovery from conventional reservoirs? The answer is yes! Paper SPE 189784 Presented at the SPE Canada Unconventional Resources Conference, Calgary, Alberta, Canada, 13-14 March, 2018.
Heath, J.E., McPherson, B.J. 2-D numerical modeling of a fault zone leaking carbon dioxide in east central Utah. Paper AGU Presented at Fall Meeting Abstracts, 2004.
Huerta, N.J., Hesse, M.A., Bryant, S.L., et al. Reactive transport of CO2 -saturated water in a cement fracture: Application to wellbore leakage during geologic CO2 storage. Int. J. Greenhouse Gas Control 2016, 44: 276-289.
Jensen, J.L., Currie, I.D. A new method for estimating the Dykstra-Parsons coefficient to characterize reservoir heterogeneity. SPE Reserv. Eng. 1990, 5(3): 369-374.
Kim, D. Scale-up of reactive flow through network flow modeling. Stony Brook, NY, USA, The Graduate School, Stony Brook University, 2008.
King, S. Reservoir Evaluation and Visualization (REV) Tool Users Manual, Version: 2016.11-1.2.0. U.S. Department of Energy, National Energy Technology Laboratory, 2016.
Krevor, S.C.M., Pini, R., Zuo, L., et al. Relative permeability and trapping of CO2 and water in sandstone rocks at reservoir conditions. Water Resour. Res. 2012, 48(2): W02532. Kumar, A., Noh, M.H., Ozah, R.C., et al. Reservoir simulation of CO2 storage in aquifers. SPE J. 2005, 10(3): 336-348.
Mathias, S.A., De Miguel, G.J.G.M., Thatcher, K.E., et al. Pressure buildup during CO2 injection into a closed brine aquifer. Transp. Porous Media 2011, 89(3): 383-397.
Mohamed, A.M.A.S. Semi-analytical solution for multiphase fluid flow applied to CO2 sequestration in geologic porous media. Texas, Texas A&M University, 2013.
Mukhopadhyay, S., Yang, S.Y., Yeh, H.D. Pressure buildup during supercritical carbon dioxide injection from a partially penetrating borehole into gas reservoirs. Transp. Porous Media 2012, 91(3): 889-911.
Myshakin, E.M., Singh, H., Sanguinito, S., et al. Numerical estimations of storage efficiency for the prospective CO2 storage resource of shales. Int. J. Greenhouse Gas Control 2018, 76: 24-31.
Nordbotten, J.M., Kavetski, D., Celia, M.A., et al. Model for CO2 leakage including multiple geological layers and multiple leaky wells. Environ. Sci. Technol. 2008, 43(3): 743-749.
Oldenburg, C.M., Cihan, A., Zhou, Q., et al. Geologic carbon sequestration injection wells in overpressured storage reservoirs: Estimating area of review. Greenhouse Gases 2016, 6(6): 775-786.
Perrin, J.C., Benson, S. An experimental study on the influence of sub-core scale heterogeneities on CO2 distribution in reservoir rocks. Transp. Porous Media 2010, 82(1): 93-109.
Shipton, Z.K., Evans, J.P., Kirschner, D., et al. Analysis of CO2 leakage through ‘low-permeability’ faults from natural reservoirs in the Colorado Plateau, east-central Utah. Geological Storage of Carbon Dioxide 2004, 233(1): 43-58.
Singh, H. Scale-up of reactive processes in heterogeneous media. Austin, University of Texas at Austin, 2014.
Singh, H. Representative elementary volume (REV) in spatio-temporal domain: A method to find REV for dynamic pores. J. Earth Sci. 2017, 28(2): 391-403.
Singh, H., Cai, J. Screening improved recovery methods in tight-oil formations by injecting and producing through fractures. Int. J. Heat Mass Transf. 2018, 116: 977-993.
Singh, H., Huerta, N.J. Detecting subsurface fluid leaks in real-time using injection and production rates. Adv. Water Resour. 2017, 110: 147-165.
Singh, H., Islam, A. Enhanced safety of geologic CO2 storage with nanoparticles. Int. J. Heat Mass Transf. 2018, 121: 463-476.
Singh, H., Srinivasan, S. Scale up of reactive processes in heterogeneous media-numerical experiments and semi-analytical modeling. Paper SPE 169133 Presented at the SPE Improved Oil Recovery Symposium, Tulsa, Oklahoma, USA, 12-16 April, 2014a.
Singh, H., Srinivasan, S. Some perspectives on scale-up of flow and transport in heterogeneous media. Bull. Can. Pet. Geol. 2014b.
Song, C., Yang, D. Performance evaluation of CO2 huff-n-puff processes in tight oil formations. Paper SPE 167217 Presented at the SPE Unconventional Resources Conference Canada, Calgary, Alberta, Canada, 5-7 November, 2013.
Wolterbeek, T.K.T., Peach, C.J., Raoof, A., et al. Reactive transport of CO2 -rich fluids in simulated wellbore interfaces: Flow-through experiments on the 1-6 m length scale. Int. J. Greenhouse Gas Control 2016, 54: 96-116.
Xiao, Y., Xu, T., Pruess, K. The effects of gas-fluid-rock interactions on CO2 injection and storage: Insights from reactive transport modeling. Energy Procedia 2009, 1(1): 1783-1790.
Yang, Z., Niemi, A., Tian, L., et al. Modelling of far-field pressure plumes for carbon dioxide sequestration. Energy Procedia 2013, 40: 472-480.
Yu, Y., Li, L., Sheng, J.J. Further discuss the roles of soaking time and pressure depletion rate in gas huff-n-puff process in fractured liquid-rich shale reservoirs. Paper SPE 181471 Presented at the SPE Annual Technical Conference and Exhibition, Dubai, UAE, 26-28 September, 2016.
Zhang, L., Dilmore, R.M., Bromhal, G.S. Effect of outer boundary condition, reservoir size, and CO2 effective permeability on pressure and CO2 saturation predictions under carbon sequestration conditions. Greenhouse Gases 2016, 6(4): 546-560.
Zuloaga, P., Yu, W., Miao, J., et al. Performance evaluation of CO2 Huff-n-Puff and continuous CO2 injection in tight oil reservoirs. Energy 2017, 134: 181-192.
Zyvoloski, G.A., Robinson, B.A., Dash, Z.V., et al. Summary of the models and methods for the FEHM application-a finite-element heat-and mass-transfer code. No. LA– 13307-MS, Los Alamos National Laboratory, 1997.
Refbacks
- There are currently no refbacks.
Copyright (c) 2018 The Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.