Multi-scale evaluation of mechanical properties of granite under microwave irradiation
Abstract view|17|times PDF download|4|times Supplements download|0|times
Abstract
Nowadays, the depletion of shallow resources drives deeper mining operations. Microwave pre-treatment has shown promise for efficient drilling in deep hard rock. While previous studies have confirmed the feasibility of microwave-assisted crushing of hard rocks and analyzed their structural and mechanical property changes at various scales, the microscopic mechanisms behind the evolution of the macro-mechanical parameters of hard rock remain unclear. This study addresses this knowledge gap. At the microscopic scale, the mineral characteristics and the micromechanical properties of minerals (including interfaces) at different sites before and after microwave irradiation were tested in typical hard granites. At the macroscopic scale, the real-time monitoring of mass and surface heating-rupturing characteristics of granite during microwave irradiation was achieved. Meanwhile, acoustic wave and uniaxial compression tests were conducted to explore the evolution of the macroscopic physical and mechanical parameters of granite before and after microwave irradiation. Variability in the mineral structure and mechanical properties accounts for differences in the uniaxial compression strength of granites. To realize the macro-micro linkage, the micro-mechanical parameters of minerals in different granite sections before and after microwave treatment were upscaled. The upscaling results, obtained using the Mori-Tanaka method, closely matched those from uniaxial compression tests, and the upscaling of mineral micro-mechanical parameters in interior samples was found to accurately predict the weakening of macro-mechanical properties of granite. This study provides insights into how microwave irradiation affects the mechanical properties of granite at a microscopic level, offering a quick and efficient method for assessing microwave weakening in deep hard rock and establishing a theoretical foundation for microwave-assisted mechanical drilling in industrial applications.
Document Type: Original article
Cited as: Gao, M., Bai, Y., Yang, B., Xie, J., Tang, R., Yang, Z., Zhang, Y. Multi-scale evaluation of mechanical properties of granite under microwave irradiation. Advances in Geo-Energy Research, 2025, 15(1): 30-43. https://doi.org/10.46690/ager.2025.01.04
Keywords
References
Ante, M. A., Lingareddy, M. G., Aminzadeh, F., et al. Nano- and micro-scale deformation behavior of sandstone and shale. Paper ARMA-2018-2055 Presented at 52nd U.S. Rock Mechanics/Geomechanics Symposium, Seattle, Washington, 17-20 June, 2018.
Ayatollahi, M., Najafabadi, M. Z., Koloor, S., et al. Mechanical characterization of heterogeneous polycrystalline rocks using nanoindentation method in combination with generalized means method. Journal of Mechanics, 2020, 36(6): 813-823.
Brady, B., Brown, E. Rock Mechanics: For Underground Mining. Dordrecht, Netherlands, Springer Dordrecht, 2007.
Broz, M. E., Cook, R. F., Whitney, D. L. Microhardness, toughness, and modulus of Mohs scale minerals. American Mineralogist, 2006, 91(1): 135-142.
BS EN ISO 14577-1:2002: Metallic materials. Instrumented indentation test for hardness and materials parameters: Test method. British Standards Institute, 2003.
Cheng, Y., Li, Z., Cheng, C. Scaling, relationships for indentation measurements. Philosophical Magazine A, 2002, 82(10): 1821-1829.
Chen, X., Cheng, Y., Xie, X., et al. Correlation between macro and micro mechanical parameters of marble based on nanoindentation experiment. Rock and Soil Mechanics, 2023, 44(12): 3551-3564.
Espinoza, W. F., Zhang, F., Dai, S. Impacts of temperature on the mechanical properties of Longmaxi shale outcrops using instrumented nanoindentation. Geomechanics for Energy and the Environment, 2022, 30: 100348.
Hartlieb, P., Grafe, B. Experimental study on microwave assisted hard rock cutting of granite. BHM Berg-und H¨uttenm¨ annische Monatshefte, 2017, 162(2): 77-81.
Hay, J. Introduction to instrumented indentation testing. Experimental Techniques, 2009, 33(6): 66-72.
Hertz, H. On the contact of elastic solids. Crelle’s Journal, 1881, 92: 156-171.
He, X., Xu, Y., Shen, S., et al. Geological environment problems during metro shield tunnelling in Shenzhen, China. Arabian Journal of Geosciences, 2020, 13(2): 87.
Hill, R. The elastic behaviour of a crystalline aggregate. Proceedings of the Physical Society Section A, 1952, 65(5): 349-354.
the microwave-drill near-field localized heating effect. Journal of Applied Physics, 2005, 97(3): 034909.
Ji, S., Wang, Q., Xia, B., et al. Mechanical properties of multiphase materials and rocks: A phenomenological approach using generalized means. Journal of Structural Geology, 2004, 26(8): 1377-1390.
Kahraman, S., Canpolat, A. N., Fener, M., et al. The assess ment of the factors affecting the microwave heating of magmatic rocks. Geomechanics and Geophysics for Geo-Energy and Geo-Resources, 2020, 6(4): 66.
Law, R. D. Deformation thermometry based on quartz c-axis fabrics and recrystallization microstructures: A review. Journal of structural Geology, 2014, 66: 129-161.
Lei, M. Study on the meso-mechanical properties and mecha nism of granite under combined action of hydrochemistry and freeze-thaw cycle based on nanoindentation test. Shaanxi, Xi’an University of Technology, 2022. (in Chinese)
Lei, M., Dang, F., Xue, H., et al. Evaluation method of granite multiscale mechanical properties based on nanoindenta tion technology. Geofluids, 2021, 2021: 1-9.
Li, C., Wang, D., Kong, L. Mechanical response of the Middle Bakken rocks under triaxial compressive test and nanoindentation. International Journal of Rock Mechanics and Mining Sciences, 2021, 139(7): 104660.
Liu, X., Xu, D., Li, S., et al. An insight into the mechanical and fracture characterization of minerals and mineral interfaces in granite using nanoindentation and micro X-Ray computed tomography. Rock Mechanics and Rock Engineering, 2023, 56(5): 3359-3375.
Liu, Y., Liu, A., Liu, S., et al. Nano-scale mechanical properties of constituent minerals in shales investigated by combined nanoindentation statistical analyses and SEM-EDS-XRD techniques. International Journal of Rock Mechanics and Mining Sciences, 2022, 159: 105187.
Lu, G., Feng, X., Li, Y., et al. The microwave-induced fracturing of hard rock. Rock Mechanics and Rock Engineering, 2019, 52: 3017-3032.
Lu, G., Li, Y., Hassani, F., et al. The influence of mi crowave irradiation on thermal properties of main rock forming minerals. Applied Thermal Engineering, 2017, 112: 1523-1532.
Lu, G., Zhou, J., Li, Y., et al. The influence of minerals on the mechanism of microwave-induced fracturing of rocks. Journal of Applied Geophysics, 2020, 180: 104123.
Maruvanchery, V., Kim, E. Mechanical characterization of thermally treated calcite-cemented sandstone using nanoindentation, scanning electron microscopy and au tomated mineralogy. International Journal of Rock Mechanics and Mining Sciences, 2020, 125: 104158.
Mavko, G., Mukerji, T., Dvorkin, J. The Rock Physics Hand book. Cambridge, United Kingdom, Cambridge Univer sity Press, 2020.
Ma, Z., Gamage, R. P., Zhang, C. Application of nanoinden tation technology in rocks: A review. Geomechanics and Geophysics for Geo-Energy and Geo-Resources, 2020, 6(4): 1-27.
Jerby, E., Aktushev, O., Dikhtyar, V. Theoretical analysis of Ma, Z., Zhang, C., Gamage, R. P., et al. Uncovering the creep deformation mechanism of rock-forming minerals using nanoindentation. International Journal of Mining Science and Technology, 2022, 32(2): 283-294.
Meng, Y. Processibility evaluation of granite based on micromechanical properties of rock-forming minerals. Fujian, Huaqiao University, 2022. (in Chinese)
Mori, T., Tanaka, K. Average stress in matrix and average elastic energy of materials with misfitting inclusions. Acta Metallurgica, 1973, 21(5): 571-574.
Mukherjee, R., Misra, S. Nanomechanics of minerals: Understandings and developments through instrumented nanoindentation techniques. Physics and Chemistry of Minerals, 2023, 50(1): 10.
Nicco, M., Holley, E. A., Hartlieb, P., et al. Methods for characterizing cracks induced in rock. Rock Mechanics and Rock Engineering, 2018, 51(7): 2075-2093.
Nicco, M., Holley, E. A., Hartlieb, P., et al. Textural and mineralogical controls on microwave-induced cracking in granites. Rock Mechanics and Rock Engineering, 2020, 53(10): 4745-4765.
Oliver, W. C., Pharr, G. M. An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments. Journal of Materials Research, 1992, 7(6): 1564-1583.
Reuss, A. Berechnung der fließgrenze von mischkristallen auf grund der plastizit atsbedingung fur einkristalle. ZAMMZeitschrift fur Angewandte Mathematik und Mechanik, 1929, 9(1): 49-58.
Róański, A., Róańska, A., Sobótka, M., et al. Identification of changes in mechanical properties of sandstone subjected to high temperature: Meso-and micro-scale testing and analysis. Archives of Civil and Mechanical Engineering, 2021, 21(1): 28.
Rui, F., Zhao, G., Zheng, Y., et al. Electromagnetic-thermo-mechanical coupled modelling of microwave-assisted TBM disc cutting. Tunnelling and Underground Space Technology, 2023, 138: 105171.
Rui, F., Zhao, G., Zhang, Y., et al. Study on the mechanism of rock damage under microwave and laser irradiation through multiscale and multiphysics numerical modelling. Rock Mechanics and Rock Engineering, 2024, 57(2): 1079-1102.
Sousa, F. J. P., Dal Bó, M., Guglielmi, P. O., et al. Characterization of Young’s modulus and fracture toughness of albite glass by different techniques. Ceramics International, 2014, 40(7): 10893-10899.
Su, X., Li, D., Zhou, A., et al. Experimental studies on mechanical properties and brittleness of granite treated with different microwave heating times. Journal of Central South University, 2023, 30(12): 4052-4065.
Swan, G. The mechanical properties of Stripa granite. Lawrence Berkeley National Laboratory, 1978.
Tang, X., Zhang, Y., Xu, J., et al. Determining Young’s modulus of granite using accurate grain-based modeling with microscale rock mechanical experiments. International Journal of Rock Mechanics and Mining Sciences, 2022, 157: 105167.
Voigt, W. Lehrbuch der Kristallphysik. Leipzig, DE, Teubuer, 1928.
Wong, L. N. Y., Zhang, Y., Wu, Z. Rock strengthening or weakening upon heating in the mild temperature range? Engineering Geology, 2020, 272: 105619.
Xie, H., Gao, M., Zhang, R., et al. Application prospects of deep in-situ condition-preserved coring and testing systems. Advances in Geo-Energy Research, 2024, 14(1): 12-24.
Yang, M., Li, J., Gao, M., et al. Experimental study on nonlinear mechanical behavior and sampling damage characteristics of rocks from depths of 4900-6830 m in Well Songke-2. Journal of Central South University, 2023, 30(4): 1296-1310.
Yang, Z., Pan, D., Zhou, J., et al. Vibration characteristics of cutter-head in soft-hard mixed stratum: An experimental case study on Su’ai tunnel. KSCE Journal of Civil Engineering, 2020, 24(4): 1338-1347.
You, M., Hua, A. Fracture of rock specimen and decrement of bearing capacity in uniaxial compression. Chinese Journal of Rock Mechanics and Engineering, 1998, 17(3): 292-296.
Zhang, J., Hu, L., Pant, R., et al. Effects of interlayer interactions on the nanoindentation behavior and hardness of 2:1 phyllosilicates. Applied Clay Science, 2013, 80-81: 267-280.
Zhao, L., Peng, R., Hao, P., et al. Effects of pore pressure on coring-induced damage based on simulation by mesoscale stress-flow coupling numerical model. Advances in Geo-Energy Research, 2024, 14(3): 170-186.
Zhu, W., Hughes, J. J., Bicanic, N., et al. Nanoindentation mapping of mechanical properties of cement paste and natural rocks. Materials Characterization, 2007, 58(11 12): 1189-1198.
DOI: https://doi.org/10.46690/ager.2025.01.04
Refbacks
- There are currently no refbacks.
Copyright (c) 2024 The Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.